[ Chinese wardrobe net ] Customized wardrobe is not a finished wardrobe, just need to move into the designated place, move to the corresponding position. Custom wardrobes often require simple assembly on site and are a complete wardrobe to be used. Manufacturers of custom-made wardrobes will have workers on-site installation, but as consumers, it is also necessary to understand how to install custom wardrobes. Custom wardrobe installation process First, the preparation stage: 1. The material is on the scene. More formal furniture manufacturers, cardboard packaging is generally shipped to the site. After unpacking, check the plates and hardware. 2. Fix the screws. The nails are generally left on the plates according to the design drawings, and the workers at the site use special tools to fix the screws. 3. Measure the side panels. Since the closet is placed against the wall, the side panel is sawn off at the position of the baseboard. After you have it, look it up and see if it fits. Second, the installation phase: 1. Place the bottom plate. The floor placed on the bottom of the wardrobe should be cleaned beforehand, because it will be very troublesome to clean up after installation. 2. Fixed frame. Install the side and back panels of the closet according to the grooves on the board and adjust the position between the boards. 3. Install the top plate. It is best to prepare a climbing stool on the scene. The top plate should be lifted up and then fixed with rivets. 4. Install the shelf. Place the shelf where you have previously screwed it and then secure it. Pay attention to the fixed position of the shelf and the back and side panels. 5. Fix the door rail. The door rails are installed on the top and bottom sides of the wardrobe. The material of the door rails is better, lighter and firmer. 6. Install the clothes rail. Fix the rivets in the reserved position and install the clothes rail. Note that the two sides should be balanced. Third, the closing stage: 1. Install the door leaf. The two sliding doors should be attached to the position of the guide rails. Fix the door leaf first and then fix the guide rails at the bottom side to avoid the phenomenon that the door leaf falls off in the future. 2. Adjustment and improvement. After all the installations are completed, make a "full inspection" of the wardrobe. If there is any deviation, adjust it in time. Fourth, the completion of acceptance: Finally, check the wardrobe: Shake the cabinet to see if it is firm and the details are in place. Customized wardrobe installation is divided into four stages, from the preparation stage to the final closing stage, there are more detailed process introduction. Consumers who need to install custom wardrobes, but also remember to check the appropriate materials before installation, so as to avoid the situation of the wrong version. Garden Spades And Forks,Spade Tool,Digging Fork,Digging Spade Ningbo Smile tools Co.,ltd , https://www.nbsmiletools.com